Basic Repairs by mail Order. Example here: a Ten Tec Argonaut 515 Audio Board.
I am only doing small repairs like this circuit board. This one came
in the other day mailed to me from USA. It is the audio board from
a Ten Tec Argonaut.

I have all the parts in stock for this board. In this case, the LM380
IC needs to be replaced- ( a very basic repair).

I dont repair entire radios unless they are my own (as a general
rule). I have found it to be too time consuming and sometimes
problems crop up when fixing old radios that are a real bugger to
fix. -- I NOW STICK TO SIMPLER REPAIRS that are basic and a joy
to do.
This repair to the Argonaut 515 board will cost the fellow $18.00
parts and labour which includes testing the board in my own
Argonaut 515 before I send it back to him. Of course, he is also
paying for the postage to and from. It is expensive enough to
send things by mail to get repaired so I keep my charges very
reasonable.

My shop rate is a very flexible $10 per hour sort of thing.
LINK BACK TO THE
HOME PAGE
NETTY ELECTRONICS
NETTY ELECTRONICS - est 2014
NOTE: anything comming here should be by MAIL and not
UPS or other commercial couriers FROM USA.

The Department of Homelands Security paper work causes
the commercial couriers to charge a  hefty "brokerage fee"
for items going across the U.S. border into Canada. The
ordinary post mail is reliable and relatively inexpensive.
NOTE the green customs sticker that has to accompany the
small parcel.
FREE ESTIMATES FOR YOUR REPAIRS all done by email
and photos as necessary. I also advise on repairs and help
out (often for free) sometimes with a bit of renumeration
but my rates are only $10 per hr (retirement prices) !
- remember .. simpler items like circuit boards above.
here is my email:  
earl@nettyelectronics.com
To view a small article I wrote about this basic
repair to a circuit board - -
CLICK HERE ---
(some good basic tips on electronics repair)
MASTER LIST of over 2,700
diferent parts I sell
-- NEW
HTML LIST 14 JULY 2015
CLICK HERE
I have thousands of parts and I have them
cataloged (or at least most of them) -- see
the LINK below and click to view BIG LIST
Here are some pictures and information on my ASSIST to a USA ham who had an
HW8 with a core that was fractured and stuck in the coil form. I did some
measurements and sent him a kit of parts to aid him fixing the coil (or perhaps
actually cloning up another good substitute. TOTAL LABOUR and parts about
$15 for this project. (my rates are retirement hobby rates- I can quote you for
any little repair/rebuild projects via email using photos ect.
CLICK HERE FOR SLUG TUNED COIL REPAIR
story in pictures (only $15 parts and labour) !